| Used Boats for sale by owner since 1983. BoatsFSBO™ |
|
|
| | |
| | | |
1973 Pacemaker Sportfish
|
| Contact Information | |
|
Kenneth
954-599-4184
|
| |
| | | | Please call boat owner Kenneth at 954-599-4184.
Boat is in Oakland Park, Florida. 28 foot 1973 Pacemaker, hand laid, fiberglass, twin engine sportfish hull.
All railings, teak pulpit, and dive platform for this boat, matching the railings bring LOA to about 32'.
All areas below decks are painted with epoxy bilge paint, all rough edges sanded first.
All stringers refurbished with Epoxy and biax fiberglass, filled with foam, reinforced with 1" x 4" x 18" x 4' aluminum box
channel where motor mounts are fastened.
All deck areas along the sides, bow, and foredeck, as well as the deck above the cabin have been professionally refurbished
with new glass and inorganic filler material Not wood.
Boat is in epoxy primer to protect the glass. 4" x 6" Solid Ipe motor mount supports 2" Copper bonding straps
installed Two brand new, not rebuilt, carbureted New carbs, not rebuilt Chrysler 318s with new fresh water Sendure heat exchangers, exhaust manifolds, and electronic ignition.
New components.
Never fired.
New 1-14" bronze and polycarbonate seawater strainers.
Two refurbished Borg Warner transmissions.
Original equipment New 18" welded aluminum fuel tanks, with baffles, installed 100 gal each New 5kw Kohler gas
powered marine generator, with sound shield, never used Refurbished 12k BTU marine AC not used since service.
Brand new 7 gal hot water heater.
Benmar courseminder
autopilot, used, working.
VHF radio and antenna.
Refurbished alcohol/electric stove
for galley.
Fireboy automatic halon below decks fire extinguisher system with sensor.
All upholstery and fold out sofa, dinette table.
Refurbished and or recovered.
Numerous new unused interior fixtures and lights, running lights, etc.
Fresh water tank Numerous pumps.
Bennett trim tabs with control switches and pumps.
A lot of wire and wiring clips.
Exhaust tubing, mufflers, and fittings.
Struts and props I have the
shafts, but they are pitted, no cutless bearings.
Rudders, reshafted with SS shafts.
Steering control parts for rudder control.
Anodized aluminum outriggers, with spreaders and swing arms.
Used electrical panel with some old breakers.
This boat has two forward berths, a fold out sofa, and dinette table that converts to a sleeping berth.
I have all the cushions in excellent condition, including the sofa.
Pix are of exterior and a couple of the bilge areas Requires assembly and paint.
If you are looking for a basket case, this is not it.
I paid real money for all of this, and you will end up with a really good boat for a fraction of its value
| | | | |
|
| | | | |
|
|